NetBackup with Tara hung table

UDA
Enthusiast

NetBackup with Tara hung table

Having a problem with backups. Using NetBackup with TARA. Last 4 nights the backup has hung on the same table for 2 hours, causing us to have to abort the job. Entire system backup usually take 40 minutes. The backup is done in 3 streams and streams 1 and 2 always complete fine and stream 3 gets hung on the same table each night. Any ideas?
1 REPLY
Enthusiast

Re: NetBackup with Tara hung table

Found the problem. The drive had run out of tapes. There is no really good way to find this out oddly enough. You can see it on a multistream job once one stream hits the max time and aborts, it loads a tape at that point for one of the other streams. Problem was difficult to find, but solution was easy enough.