Workload designer - End Action alert from end of state change condition not sent

Viewpoint
Enthusiast

Workload designer - End Action alert from end of state change condition not sent

Hi We have a TDWM state change condition set (unplanned event), with an alert (email) to advise when the state change takes place and when it reverts back.  We have selected the same alert type for the start action and end action of the state change, however did not receive an email for the end condition. The Event name is "EV-LowAvailAWTs", and set as a minimum of 15 minutes (900 seconds), and received emails: Start event 1: TDWM: Expression 'SysCon_ALERT_BEGIN_EV-LowAvail' was triggered at 2016-12-10_03:14:59.77838 Event Timestamp: 2016-12-10T03:33:38.764+11:00 EventValue=0 RequestTimestamp=2016-12-10T03:33:37.880+11:00 Description: SysCon_ALERT_BEGIN_EV-LowAvail and Start event 2: TDWM: Expression 'SysCon_ALERT_BEGIN_EV-LowAvail' was triggered at 2016-12-10_03:35:01.654107 Event Timestamp: 2016-12-10T03:38:41.420+11:00 EventValue=0 RequestTimestamp=2016-12-10T03:35:00.933+11:00 Description: SysCon_ALERT_BEGIN_EV-LowAvail Therefore the state change was triggered twice, but there was no end state email received. The first alert seems a little strange, in that the state change was triggered at 03:14, but it's event TS was 03:33, perhaps this excluded the end state alert as end state may have been around 03:29 (03:14 + 15mins(900 secs)).  Even if this was the case, then should have received an email for the end state of the second state change. Is anybody able to advise if they receive a start and end state notification ?   NB:  We are running TD 15.00 and Viewpoint 15.11.00.03 (Workload Designer portlet also 15.11.00.03). Cheers Steve